Magnetek Enrange CAN-6 Manuel d'instructions télécharger pdf (Page 39)

Flex 8EX System Instruction Manual

December 2013

Page 39 of 44

3rd

SPEED

e. Now press any push button on the transmitter handset to operate the crane or

equipment. During transmitter inactivity (push buttons not pressed), the transmitter will

automatically switch to standby mode, with an orange blink on the Status LED at every 4-

second interval.

f. In case of an emergency, pressing the red emergency stop button will immediately

disconnect the receiver mainline (Status LED blinks red). To reset the emergency

stop button, just rotate the red button either clockwise or counter-clockwise so it pops

up. When the green light appears, rotate the power key to “Start” position to resume

operation (depends on JP3 setting on page 32).

g. After 5 minutes of inactivity (push buttons have not been pressed) the receiver MAIN

will be disconnected temporarily (depends on JP1 & JP2 settings on page 32). To

resume operation just rotate the power key switch to START position to reconnect the

receiver MAIN.

h. Turn off the transmitter power by rotating the power key counter-clockwise to the “Off”

position; it will disconnect the transmitter power and the receiver MAIN altogether. Turn it

further counter-clockwise to release the key.

7.1.2 A/B Selector Push Button Operating Procedure

Pressing the “Select A/B” push button will toggle between output relay A, B and A+B

respectively. There are 4 different types of Select A/B sequences available, please refer to

page 19 for instructions on how to set Select A/B functions.

7.1.3 3

Speed Push Button Operating Procedure

When a push button is held at 2

speed, pressing the 3

Speed push button one time will

activate the 3

speed output relay (toggled). If the operator wants 2

speed again, just

press the 3

Speed push button one more time.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Magnetek Enrange CAN-6 Manuel d'instructions Page 39