Magnetek Flex 12RS System Informations techniques télécharger pdf (Page 33)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 33 of 49

4.9.1 DIGITAL INPUT MODULE LED OPERATION

When the Flex M system is supplying power to the Digital Input module, there is an LED that indicates the

power and communication status of the Relay module.

Figure 32. GEN1 Digital Input Module LED Placement

 OK LED

o Solid indicates module communication with system is good

o 3 Blinks indicates read/write error to attached CPU module

Additionally, there are 8 LEDs labeled 1 through 8 on the Digital Input module. When the LED is on, this

indicates that the module is receiving a signal/input at that input.

 LED1

o Digital Input 1 is active (non-zero)

 LED2

o Digital Input 2 is active (non-zero)

 LED3

o Digital Input 3 is active (non-zero)

 LED4

o Digital Input 4 is active (non-zero)

 LED5

o Digital Input 5 is active (non-zero)

 LED6

o Digital Input 6 is active (non-zero)

 LED7

o Digital Input 7 is active (non-zero)

 LED8

o Digital Input 8 is active (non-zero)

Inputs 9-12 do not have a viewable LED.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 48 49

Pas de commentaire

Magnetek Flex 12RS System Informations techniques Page 33