Magnetek Flex 12EX System Manuel d'utilisateur télécharger pdf (Page 10)

Page 9

71423 56 8

CHANNEL

71 423 56 8

4. Function Settings

A. TRANSMITTER HANDSET

1. System Channel Settings

(Fig. 07)

Set the transmitter channel by adjusting the channel dip-switch located on the backside of the

transmitter encoder board (refer to Fig. 07 above). Only the first six (6) positions are used for channel

programming (refer to Fig. 08 below). The system channels table located on page 24 illustrates which

dip-switch setting corresponds to which channel. Once the transmitter channel is altered do make sure

to change receiver channel as well. The channel on both transmitter and receiver must be identical in

order for system to work. To change receiver channel please refer to page 15.

Example: Top slot → “1”

Bottom slot → “0”

(Fig. 08)

The above dip-switch setting “1 0 0 1 0 0” corresponds to “channel 36” in the system channels table

on page 24.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Pas de commentaire

Magnetek Flex 12EX System Manuel d'utilisateur Page 10