Magnetek Flex 12EX System Manuel d'utilisateur télécharger pdf (Page 23)

Page 22

JP7

JP1

JP5

JP3

JP2

JP4

JP6

5. Jumper Settings

Jumper settings are applied to functions such as mainline-disconnect time, Start function, transmitter

push button layout, system information (serial number/ID code and channel) programming and system

testing. The jumpers #1 ~ #7 are located on the decoder module above the four (4) dip-switches (refer

to Fig.16 below).

(Fig. 16)

▇ Manufacture preset

Jumper Settings Function

JP1

(Blank)

JP2

(Blank)

Receiver MAIN remained closed unless the transmitter power is turned

off or emergency stop command is initiated.

JP1

(Inserted)

JP2

(Blank)

Receiver MAIN opens after 5 minutes of inactivity.

JP1

(Blank)

JP2

(Inserted)

Receiver MAIN opens after 30 minutes of inactivity.

JP1

(Inserted)

JP2

(Inserted)

Receiver MAIN opens after 60 minutes of inactivity.

JP3

(Blank)

After turning on the transmitter power key switch or after resetting the

emergency stop button, press any push button to activate the receiver MAIN.

JP3

(Inserted)

After turning on the transmitter power key switch or after resetting the

emergency stop button, rotate the power key to “START” position to activate

the receiver MAIN.

JP4

(Blank)

JP5

(Blank)

Standard right-to-left push button configuration for all models.

JP4

(Inserted)

JP5

(Blank)

In-line push button configuration (top to bottom) for FLEX 8ES/EX.

JP4

(Blank)

JP5

(Inserted)

In-line push button configuration (top to bottom) for FLEX 12ES/EX.

JP4

(Inserted)

JP5

(Inserted)

In-line push button configuration (top to bottom) for FLEX 4ES/EX.

JP6

(Blank)

Program system serial number/ID code and channel from decoder module

to I-CHIP.

JP6

(Inserted)

Program system serial number/ID code and channel from I-CHIP

to decoder module.

JP7

(Inserted)

For system test only, receiver MAIN disabled.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Magnetek Flex 12EX System Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Magnetek Flex 12EX System