Magnetek Flex 12EX System Manuel d'utilisateur télécharger pdf (Page 30)

Page 29

3rd

SPEED

e. Now press any push button on the transmitter handset to operate the crane or equipment.

f. In case of an emergency, pressing down the red emergency stop button will immediately

disconnect the receiver mainline (Status LED blinks red). To reset the emergency stop

button just rotate the red button either clockwise or counter clockwise, it will pop up. When

green light appears, rotate the power key to “Start” position to resume operation (depends

on JP3 setting on page 22).

g. After 5 minutes of inactivity (push button not pressed) the receiver MAIN will be

disconnected temporarily (depends on JP1 & JP2 settings on page 22). To resume operation

just press any push button on the transmitter, this will reconnect the receiver MAIN

automatically.

h. To turn off the transmitter handset just rotate the power key to “Off” position, it will

disconnect the transmitter power and the receiver MAIN altogether.

2. A/B Selector Push Button Operating Procedure

Pressing the “Select A/B” push button will toggle between output relay A, B, A+B respectively.

There are 4 different types of Select A/B sequence available, please refer to page 11 for

instructions on how to set Select A/B functions.

3. 3

Speed Push Button Operating Procedure

When a push button is hold at 2

speed, pressing the 3

Speed push button one time will activate

the 3

speed output relay (toggled). If the operator wants 2

speed again, just press the 3

Speed

push button one more time.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Magnetek Flex 12EX System Manuel d'utilisateur Page 30